Published
2021-10-12
Issue
Section
Original Research Article
License
The Author(s) warrant that permission to publish the article has not been previously assigned elsewhere.
Author(s) shall retain the copyright of their work and grant the Journal/Publisher right for the first publication with the work simultaneously licensed under:
OA - Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NC 4.0). This license allows for the copying, distribution and transmission of the work, provided the correct attribution of the original creator is stated. Adaptation and remixing are also permitted.
This license intends to facilitate free access to, as well as the unrestricted reuse of, original works of all types for non-commercial purposes.
How to Cite
Photocatalytic degradation of ammonia-nitrogen via N-doped graphene/bismuth sulfide catalyst under near-infrared light irradiation
Wenxiao Liu
Jiangsu Key Laboratory of Environmental Functional Materials
Shouqing Liu
Jiangsu Key Laboratory of Environmental Functional Materials
DOI: https://doi.org/10.24294/ace.v4i2.1357
Keywords: NG/Bi2S3, Near-infrared, Photocatalysis, Ammonia Nitrogen, Degradation
Abstract
The N-doped graphene/bismuth sulfide (NG/Bi2S3) composite was synthesized by hydrothermal method. The structure and properties of the catalyst were characterized by X-ray powder diffraction, Raman spectroscopy, scanning electron microscopy and UV-visible near-infrared diffuse reflectance spectroscopy. The degradation of ammonia-N was studied using 0.050 g NG/Bi2S3 as photocatalyst under near-infrared light irradiation. The results show that the degradation ratio of ammonia-N reaches 91.4% in 100.0 mg·L-1 ammonia-N solution with pH 9.0 under near-infrared light irradiation for 10 h. Under similar conditions,the degradation ratio of ammonia-N is only 65.5% when pure Bi2S3 is used as the photocatalyst. Kinetic studies show that the ammonia-N degradation follows the first-order reaction kinetics, and the average value of the apparent rate constant is 0.1240 h-1. Catalyst stability studies show that the degradation ratio of ammonia nitrogen in 7 runs is still greater than 85.5%, which indicates that the NG/Bi2S3 composite catalyst is very stable.References
[1] Sivic A, Atanasova N, Puig S, et al. Ammonium removal in landfill leachate using SBR technology: Dispersed versus attached biomass. Water Science & Technology 2018; 77(1): 27–38.[2] Zhou Y, Xiao B, Liu S, et al. Photo-Fenton degradation of ammonia via a manganese-iron double-active component catalyst of graphene-manganese ferrite under visible light. Chemical Engineering Journal 2016; 283: 266–275.
[3] Benáková A, Johanidesová I, Kelbich P, et al. The increase of process stability in removing ammonia nitrogen from wastewater. Water Science and Technology 2018; 77(9-10): 2213–2219.
[4] Xiao S, Wang D, Zhang K, et al. Enhanced photoelectrocatalytic degradation of ammonia by in situ photoelectrogenerated active chlorine on TiO2 nanotube electrodes. Journal of Environmental Sciences 2016; 50(12): 103–108.
[5] Zhang M, He S, Tang W, et al. Disposal of low concentration ammonia-nitrogen wastewater using TiO2/biochar composite. Research of Environmental Sciences 2017; 30(9): 1440–1447.
[6] Chmielowski R, Pere D, Bera C, et al. Theoretical and experimental investigations of the thermoelectric properties of Bi2S3. Journal of Applied Physics 2015; 117(12): 125103.
[7] Fang M, Jia H, He W, et al. Construction of flexible photoelectrochemical solar cells based on ordered nanostructural BiOI/Bi2S3 heterojunction films. Physical Chemistry Chemical Physics 2015; 17(20): 13531.
[8] Li M, Wang J, Zhang P, et al. Superior adsorption and photoinduced carries transfer behaviors of dandelion-shaped Bi2S3@MoS2: Experiments and theory. Scientific Reports 2017: 7: 42484.
[9] Li Y, Fang X, Wang Y. Preparation of Bi2S3 micro/nano materials with various morphologies by hydrothermal method. Experimental Technology and Management 2017; 34(9): 47–51, 55.
[10] Ilanthamizhan C, Manikandan A, Antony SA. Facile synthesis, structural, morphological and electrochemical properties of bismuth sulfide (Bi2S3) nanostructure. Journal of Nanoscience & Nanotechnology 2017; 17(2): 1193–1197.
[11] Sharma S, Khare N. Synthesis of bismuth sulfide nanostructures for photodegradation of organic dye. Dae State Physics Symposium 2016; 2017; Odisha.
[12] Cai A, Chang Y, Wang X, et al. Graphitic carbon nitride decorated with S, N co-doped graphene quantum dots for enhanced visible-light-driven photocatalysis. Journal of Alloys & Compounds 2017; 692: 183–189.
[13] Peter CN, Anku WW, Sharma R, et al. N-doped ZnO/graphene oxide: A photostable photocatalyst for improved mineralization and photodegradation of organic dye under visible light. Ionics 2019; 25: 327–339.
[14] Lin L, Nie Y, Kavadiya S, et al. N-doped reduced graphene oxide promoted nano TiO2, as a bifunctional adsorbent/photocatalyst for CO2, photoreduction: Effect of N species. Chemical Engineering Journal 2017; 316: 449–460.
[15] Bu X, Yang S, Bu Y, et al. Highly active black TiO2/N-doped graphene quantum dots nanocomposites for sunlight driven photocatalytic sewage treatmen. Chemistry Select 2018; 3(1): 201–206.
[16] Zhang W, Zhang X, Dong X, et al. Synthesis of N-doped graphene oxide quantum dots with the internal P-N heterojunction and its photocatalytic performance under visible light illumination. Journal of Advanced Oxidation Technologies 2018; 21(1).
[17] Liu S, Xiao B, Feng L, et al. Graphene oxide enhances the Fenton-like photocatalytic activity of nickel ferrite for degradation of dyes under visible light irradiation. Carbon 2013; 64(9): 197–206.
[18] Zhou B, Shen A. Determination of ammonia nitrogen in water by Nessler reagent spectrophotometry. Low Carbon World 2017; 2017(8): 4.
[19] Huang W, Xing C, Wang Y, et al. Facile fabrication and characterization of two-dimensional bismuth (III) sulfide nanosheets for high-performance photodetector applications under ambient conditions. Nanoscale 2018; 10(5): 2402–2412.
[20] Yang C, Li Z, Yu Y, et al. Mesoporous zinc ferrite microsphere-decorated graphene oxide as a flame retardant additive: preparation, characterization, and flame retardance evaluation. Industrial & Engineering Chemistry Research 2017; 56(27): 7720–7729.
[21] Hsieh C, Liu W. Synthesis and characterization of nitrogen-doped graphene nanosheets/copper composite film for thermal dissipation. Carbon 2017; 118: 1–7.
[22] Baishya K, Ray JS, Dutta P, et al. Graphene-mediated band gap engineering of WO3 nanoparticle and a relook at Tauc equation for band gap evaluation. Applied Physics A 2018; 124(10): 1–6.
[23] Yang H, Yao R. Effects of pH level and nitrifying bacteria concentration on ammonia oxidation rate. Chinese Journal of Environmental Engineering 2017; 11(5): 2660–2665.
[24] Zhou S, Xiao B, Liu C, et al. Photocatalytic degradation of ammonia via graphene oxide-nickel ferrite hybrid catalyst under visible light irradiation. Journal of Suzhou University of Science and Technology (Natural Science Edition) 2016; 33(2): 23–29.
[25] Liu S, Zhu X, Zhou Y, et al. Smart photocatalytic removal of ammonia through molecular recognition of zinc ferrite/reduced graphene oxide hybrid catalyst under visible-light irradiation. Catalysis Science & Technology 2017; 7(15): 3210–3219.
[26] Xue T, Zhang H, Liu S. Synthesis of reduced graphene oxide-cerium oxide hybrid catalyst and the degradation of ammonia under visible light irradiation. Journal of Functional Materials 2017; 48(3): 3218–3222.