Published
2025-09-24
Issue
Section
Original Research Article
License
Copyright (c) 2025 Rusul J.L. Aljuburi, Alaa K.H. Al-Khalaf*, Hussein A.H. Al-Keriawy

This work is licensed under a Creative Commons Attribution 4.0 International License.
The Author(s) warrant that permission to publish the article has not been previously assigned elsewhere.
Author(s) shall retain the copyright of their work and grant the Journal/Publisher right for the first publication with the work simultaneously licensed under:
OA - Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NC 4.0). This license allows for the copying, distribution and transmission of the work, provided the correct attribution of the original creator is stated. Adaptation and remixing are also permitted.

This license intends to facilitate free access to, as well as the unrestricted reuse of, original works of all types for non-commercial purposes.
How to Cite
Efficiency of chitosan catalyst in removing malachite green from their aqueous solutions
Rusul J.L. Aljuburi
Environmental Pollution Dep., College of Environmental Sciences, Al-Qasim Green University, 51013, Babylon, Iraq.
Alaa K.H. Al-Khalaf
Environmental Pollution Dep., College of Environmental Sciences, Al-Qasim Green University, 51013, Babylon, Iraq.
Hussein A.H. Al-Keriawy
Environmental Pollution Dep., College of Environmental Sciences, Al-Qasim Green University, 51013, Babylon, Iraq.
DOI: https://doi.org/10.59429/ace.v8i3.5717
Keywords: Chitosan; malachite green dye; green treatment; solid catalyst; water environment
Abstract
This paper describes a green method for treating chemical contamination caused by malachite green from their aqueous solutions using chitosan as a solid catalyst under suitable reaction conditions, including dye concentrations, reaction time, catalyst amounts, and pH. Using UV-Visible measurements, complete removal (99%) was achieved under reaction conditions (80 ppm, 2 hr., 0.08 g, and pH = 11), respectively.
The removal reaction was caused by chemical adsorption on the chitosan surface by using Fourier transform infrared (FT-IR) spectroscopy. The chitosan spectrum was clearly changed after treatment as well as exhibiting absorption bands was appeared and vanished in the fingerprint region (400–1400 cm-1). Additionally, new bands were seen in the broad band of (O-H) groups at (3415.93-3462.22 cm-1) and secondary imine groups at (1604.77 cm-1) and at double-bond region (1500-2000 cm-1).
Accordingly, changes in the catalyst surface were observed both before and after the removal reaction using atomic force microscopy (AFM). Furthermore; the Nano scale characteristics, surface roughness, particle size, and topography parameters were examined. The surface area increased dramatically from (953.9 to 5224 nm²) and the mean diameter of the surface particles increased significantly from (23.70 to 54.94 nm), these changes were resulted from the malachite green adsorption on the surface.
With the arithmetic mean height increasing from (18.65 to 45.01 nm) and the root-mean-square height increasing from (20.49 to 50.27 nm), the topological parameters of the chitosan surface also showed a significant increase in roughness. The results clearly indicated that the removal reaction occurred on the chitosan surface through its high chemisorption capacity and catalytic oxidation of malachite green.
References
[1]. Lindsay CS, Alisher M, Tor AB, et.al. Climate change impacts on water security in global drylands, One Earth, (2021). 4(6), 851-864. https://doi.org/10.1016/j.oneear.2021.05.010.
[2]. Otálora A, Lerma TA, Arrieta-Urango Y . Palencia M. Emerging organic pollutants in aqueous environments: Detection, monitoring, and removal techniques, J. Sci. Technol. Appl., (2021). 10, 92-153. https://doi.org/10.34294/j.jsta.21.10.68.
[3]. Kareem RF, Al-Khalaf AHRemoval of Tetracycline From Water Using Nanocellulose, Procedia Environmental Science, Engineering and Management, (2024). 11(3), 451-464.
[4]. Wolf S, Esser V, Lehmkuhl F, Schüttrumpf H Longtime impact of a large dam on its downstream river’s morphology: determined by sediment characteristics, pollutants as a marker, and numerical modeling, Journal of Sedimentary Environments, (2022). 7:403–424. https://doi.org/10.1007/s43217-022-00103-9.
[5]. Bishnu KS, Pushpendra KS, Arun G. Analysis of Chemical-Biological and Physical-Biological Hybrid Systems for Wastewater Treatment Utilizing Aeration and Ozonation, Letters in Applied NanoBioScience, (2024). 14(1), 11. https://doi.org/10.33263/LIANBS141.011.
[6]. Nirav P. Raval, Prapti U. Shah, Nisha K. Shah. Malachite green ‘‘a cationic dye’’ and its removal from aqueous solution by adsorption, Appl Water Sci., (2016). https://doi.org/10.1007/s13201-016-0512-2.
[7]. Slama HB, Chenari Bouket A., Pourhassan Z, et.al. Diversity of Synthetic Dyes from Textile Industries, Discharge Impacts and Treatment Methods. Applied Sciences, (2021). 11(14), 6255. https://doi.org/10.3390/app11146255.
[8]. Mersmann, L., Souza, V. G. L., & Fernando, A. L. (2025). Green Processes for Chitin and Chitosan Production from Insects: Current State, Challenges, and Opportunities. Polymers, 17(9), 1185. https://doi.org/10.3390/polym17091185.
[9]. Teng WL, Khor E, Tan TK, et.al Concurrent production of chitin from shrimp shells and fungi, Carbohydrate Research, (2001). 332,(3), 305-316. https://doi.org/10.1016/S0008-6215(01)00084-2.
[10]. Bekçi Z, Ozveri C, Seki Y, Yurdakoç K Sorption of malachite green on chitosan bead, J. Hazard Mater., (2007). 154(1-3), 254-61. https://doi.org/10.1016/j.jhazmat.2007.10.021.
[11]. Muinde, VM, Onyari, JM, Wamalwa, B, Wabomba, JN Adsorption of malachite green dye from aqueous solutions using mesoporous chitosan–zinc oxide composite material, Environmental Chemistry and Ecotoxicology, (2020). 2, 115-125. https://doi.org/10.1016/j.enceco.2020.07.005.
[12]. Al-Khalaf A, Abdali K, Mousa, AO and Zghair, MA Preparation and structural properties of liquid crystalline materials and its transition metals complexes. Asian Journal of Chemistry, (2019). 31(2), pp.393-395.
[13]. Jackson M and HH Mantsch, “Biomedical Infrared Spectroscopy,” In: H. H. Mantsch and D. Chapman, Eds., Infrared Spectroscopy of Biomolecules, Wiley-Liss, New York, 1996, pp. 311-340.
[14]. Bangyekan, C, Aht-Ong, D, Srikulkit, K Preparation and properties evaluation of chitosan-coated cassava starch films, Carbohydrate Polymers, (2006). 63(1), 61-71. https://doi.org/10.1016/j.carbpol.2005.07.032.
[15]. Goswami R, Mishra A, Bhatt N, and Prasad B Chitosan/NC Based Bio Composite Membrane: An Impact of Varying Amount of Chitosan on Filtration Ability for the Malachite Green Dye, Journal of Graphic Era University, (2022). 10(2), 117–132. https://doi.org/10.13052/jgeu0975-1416.1024.
[16]. Ngah, WS, Fatinathan, AK, Ng PW Adsorption of chromium from aqueous solution using chitosan beads, Adsorption, (2006). 12, 249-257.
[17]. Muinde, VM, Onyari, JM, Wamalwa, B, Wabomba J and Nthumbi, RM Adsorption of Malachite Green from Aqueous Solutions onto Rice Husks: Kinetic and Equilibrium Studies, Journal of Environmental Protection, (2017). 8, 215-230. https://doi.org/10.4236/jep.2017.83017.








