Applied Chemical Engineering

A novel method for the remediation of environmental impacts of oil spills using poly carboxymethylcellulose coated (Fe2O3, Al2O3, and Ag) nanoparticles

Khamael Abd Alsalam

Department of Environment, College of Science, University of AL-Qadisiyah, Iraq

Mohamed Ali Mutar

Department of Chemistry, College of Science, University of AL-Qadisiyah, Iraq

DOI: https://doi.org/10.59429/ace.v9i1.5884

Keywords: Remediation;Oil Spills; Carboxymethylcellulose; Nanoparticles; Polymer Coated.

---

Abstract

Large-scale oil spills and the discharge of oily effluents from ships and industrial operations pose serious environmental threats and often result in significant economic consequences. Conventional cleanup methods remain largely ineffective and may themselves cause ecological damage, yet nanotechnology offers a promising alternative for addressing oil contamination. In this study, polycarboxymethycellulose-coated nanoparticles (Fe2O3, Al2O3, and Ag) were synthesized via a simple, cost-effective hydrothermal technique and applied to remove Basra crude oil (API-32) from synthetic seawater under realistic environmental conditions. The physicochemical properties of these materials were characterized using FTIR and SEM analyses, while fluorescence and proton nuclear magnetic resonance spectroscopy confirmed near-complete oil-water separation under optimized conditions. Gas chromatography-mass spectrometry results showed that approximately 100 percent of lower molecular weight alkanes (C9–C21) were eliminated within 6 hours, and extending treatment to 24 hours removed more than 67 percent of C22–C25 alkanes. Among the tested materials, CMC-coated Ag nanoparticles demonstrated the highest removal efficiency at an optimal loading of 1.6 wt percent, with disintegration order following Ag > Fe2O3 > Al2O3. The superior performance of nano-Ag is attributed to its greater surface area, smaller particle size, homogeneous morphology, and strong oil adsorption capacity. Additionally, preliminary investigations assessed potential genotoxic effects and, for the first time, examined the ability of these nanoparticles to mitigate crude oil-induced genotoxicity in vivo, confirming their potential for rapid and effective oil removal.

---

References

[1]. National Commission on the BP Deepwater Horizon Oil Spill and Offshore Drilling. Deep Water: The Gulf Oil Disaster and the Future of Offshore Drilling. Washington, DC: US Government Printing Office; 2014.

[2]. US Environmental Protection Agency (EPA). Cruise Ship Discharge Assessment Report. EPA 842-R-07-005; 2008.

[3]. Yoshioka G, Carpenter M. Characteristics of reported inland and coastal oil spills. US Environmental Protection Agency; 2002.

[4]. Aldy JE. Real-time economic analysis and policy development during the BP Deepwater Horizon oil spill. Vanderbilt Law Review. 2011;64(6):1795–1817.

[5]. Fingas M. The Basics of Oil Spill Cleanup. 2nd ed. Boca Raton: Taylor & Francis; 2000.

[6]. Harvey S, Elashvili I, Valdes JJ, Kamely D, Chakrabarty AM. Enhanced removal of Exxon Valdez spilled oil from Alaskan gravel by a microbial surfactant. Nat Biotechnol. 1990;8(3):228–230.

[7]. Federal Interagency Solutions Group. Oil Budget Calculator: Deepwater Horizon—Technical Document. NOAA; 2010.

[8]. NOAA. Environmental impacts of dispersants. Available from: http://response.restoration.noaa.gov

[9]. Atlas RM, Hazen TC. Oil biodegradation and bioremediation: a tale of the two worst spills in U.S. history. Environ Sci Technol. 2011;45(16):6709–6715.

[10]. Deng D, Prendergast DP, MacFarlane J, Bagatin R, Stellacci F, Gschwend PM. Hydrophobic meshes for oil spill recovery devices. ACS Appl Mater Interfaces. 2013;5(3):774–781.

[11]. Lahann J. Environmental nanotechnology: nanomaterials clean up. Nat Nanotechnol. 2008;3(6):320–321.

[12]. Fabrega J, Luoma SN, Tyler CR, Galloway TS, Lead JR. Silver nanoparticles: behaviour and effects in the aquatic environment. Environ Int. 2011;37(2):517–531.

[13]. Chen X. Molecular Imaging Probes for Cancer Research. World Scientific; 2012.

[14]. Gong JL, Wang B, Zeng GM, Yang CP, Niu CG, Niu QY, Zhou WJ, Liang Y. Removal of cationic dyes from aqueous solution using magnetic multi-wall carbon nanotube nanocomposite as adsorbent. J Hazard Mater. 2009;164:1517–1522.

[15]. Sharma YC, Srivastava V, Singh VK, Kaul SN, Weng CH. Nano-adsorbents for the removal of metallic pollutants from water and wastewater. Environ Technol. 2009;30(6):583–609.

[16]. Wu L, Zhang J, Li B, Wang A. Magnetically driven super durable superhydrophobic polyester materials for oil/water separation. Polym Chem. 2014;5(7):2382–2390.

[17]. Calcagnile P, Fragouli D, Bayer IS, Anyfantis GC, Martiradonna L, Cozzoli PD, Cingolani R, Athanassiou A. Magnetically driven floating foams for the removal of oil contaminants from water. ACS Nano. 2012;6(6):5413–5419.

[18]. Ge B, Zhang Z, Zhu X, Men X, Zhou X. A superhydrophobic/superoleophilic sponge for the selective absorption of oil pollutants from water. Colloids Surf A. 2013;429:129–133.

[19]. Nguyen DD, Tai NH, Lee SB, Kuo WS. Superhydrophobic and superoleophilic properties of graphene-based sponges fabricated using a facile dip coating method. Energy Environ Sci. 2012;5(7):7908–7912.

[20]. Mansoori GA, Bastami TR, Ahmadpour A, Eshaghi Z. Environmental application of nanotechnology. Annual Review of Nano Research. 2008;2:439–493.

[21]. BP. Gulf Science Data Reference: Oil Characterization Data. 2014.

[22]. Silverstein RM, Webster FX, Kiemle DJ. Spectrometric Identification of Organic Compounds. 7th ed. Wiley; 2005.

[23]. Pretsch E, Bühlmann P, Badertscher M. Structure Determination of Organic Compounds: Tables of Spectral Data. 4th ed. Springer; 2009.

[24]. Pavia DL, Lampman GM, Kriz GS, Vyvyan JA. Introduction to Spectroscopy. 4th ed. Brooks/Cole; 2009.

[25]. Law AT. Acute and chronic toxicity of Malaysian crude oil water-soluble fraction. ASEAN Marine Environmental; 1997.

[26]. Song JE, Phenrat T, Marinakos S, Xiao Y, Liu J, Wiesner MR, Tilton RD, Lowry GV. Hydrophobic interactions of nanoparticles increase sorption of phenanthrene. Environ Sci Technol. 2011;45(14):5988–5995.

[27]. Baalousha M, Nur Y, Römer I, Tejamaya M, Lead JR. Effect of monovalent and divalent cations, anions and fulvic acid on aggregation of citrate-coated silver nanoparticles. Sci Total Environ. 2013;454–455:119–131.

[28]. Coey JMD. Magnetism and Magnetic Materials. Cambridge University Press; 2010.

[29]. Palchoudhury S, Lead JR. A facile and cost-effective method for separation of oil–water mixtures using polymer-coated iron oxide nanoparticles. Environ Sci Technol. 2014;48(24):14558–14563.

[30]. Ehsanizadeh SA, Ahmadi-Kashani M, Abdulhusain ZH, Abed MJ, Salavati-Niasari M. Highly efficient ZnCo2O4 nanospheres and ZnCo2O4/GO nanocomposites as visible light photocatalysts for degradation of organic pollutants. Appl Water Sci. 2025;15(6):128.